3/15/2024 0 Comments Pi amiga emulatorOptional step, get and build wip-crap development version This MUST be run disconnected from the PiStorm, just power up the Pi with USB and do it outside the Amiga entirely. Usually a reboot is recommended here, but in this case not necessary, so continue with the section below and install some packages and test the GPIOs. (everything except the basic installation can be done without network connectivity, but it is easier to do it over SSH than at the terminal) Using raspi-config, set wifi-credentials (System Options) and activate SSH (Interface Options). Use the official Raspberry Pi Imager or a third party tool like BalenaEtcher to write the Lite version of Raspberry Pi OS to a SD-card and start up the pi This is not the only way to do things, and necessarily not the best way, it’s my way □ Pi setup In this guide, I explain how I set up the piStorm, beginning from a fresh board (with just the pins and pi header soldered onto it) until it starts up the Kickstart “insert disk” screen.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |